Revit Slate H2O Textile Gloves Black

The Slate H2O motorcycle gloves redefine the standard when it comes to Urban waterproof, short-cuffed gloves. While graphic design language is subtle, these motorcycle gloves have nice detailing to them. We also incorporate the new reflective PWR|Fuse material at the back of the hand and fingers, not only for good looks but for added dimension and texture.

MATERIAL:

• Leather Connect Finger Tip: Never remove your gloves to answer your phone or use your navigation system again. The connect fingertip leather has been developed specifically to operate touch screens.
• Hypalon pull tab at cuff
• PWR|Shell stretch
• Reflective PWR|fuse
• Suede leather with WR finish

PROTECTION:

• Injected Flex Knuckle: This knuckle protection is injected in the upper material which makes it very flexible and abrasion resistant. Due to its structure it ventilates very well while keeping you safe.
• Temperfoam knuckle
• Temperfoam palm slider
• Temperfoam thumb knuckle
• TPU Hard Shell Palm Slider: Palm slider made of a durable and high abrasion resistant TPU material at the palm side of the glove. The palm slider makes sure that the glove slides in case the palm of the hand comes in contact with the asphalt. The abrasion resistance of gloves equipped with these sliders is greatly increased, thus reducing the risk of injury significantly.

FEATURES:

• Conductive Fingertip At Index Finger: Never take off your gloves again to answer your phone or navigation system. The connect fingertip has been specifically designed to operate touch screens.
• Conductive fingertip at thumb
• Short cuff
• Stretch at cuff
• Suede leather visor wiper
• Closure: Hook and loop closure
• Tri-Fleece Liner: This polyester tricot fabric is used for glove lining, and brushed to provide extra warmth without adding any bulk. The lining wicks moisture away, to prevent hands from getting damp.

VISIBILITY:

• Reflection at finger

ADJUSTABILITY:

• Adjustment tab at cuff
• Stretch at thumb

INSULATION:

• 3M Thinsulate G 100g: Thinsulate G insulation features large air pockets to trap heat, allowing a garment to remain extremely warm for an extended period of time. The spacious air pockets also allow a garment to remain lightweight and quick to dry.

WATERPROOFING:

• Hydratex®| Z-liner: A waterproof layer is laminated onto a carrier to construct the Revit hydratex®| Z-liner membrane. The carrier, in turn, protects the membrane against wear-and-tear damage, and the seams of the membrane are taped to ensure waterproofing. The Z-liner is constructed between the lining and the outer shell. The Revit hydratex®| Z-liner membrane is used in garments that demand a high level of all-weather protection.

CERTIFICATION:

• These gloves are certified according to the EN 13594 Standard, published in 2015 and have achieved level 1 KP rating.